Complete solutions, tailored to your needs Customize →
Home » Anti-Drone Systems » Drone Jammers » Portable Type » ETLD-PJ04 Trolley Drone Jammer 4-Band 2000m

ETLD-PJ04 Trolley Drone Jammer 4-Band 2000m

TLD-PJ04 Trolley Drone Jammer: custom 0.9/GPS/2.4/5.8GHz, 4 channels, 100W (5.8GHz 50W), omni 1000m, directional 2000m, 4 batteries, omni/directional antennas.

Application Scenarios: Critical Infrastructure Protection, Event Security, Law Enforcement, Military Defense, VIP Protection
Jamming frequency Customizable; 0.9/GPS/2.4/5.8GHz
Jamming range Omni 0–1000m; directional 0–2000m
Channels 4
Battery 4 × removable
Antennas Omni + directional
Output power 100W on 0.9/GPS/2.4; 50W on 5.8GHz

The ETLD-PJ04 is built into a trolley case. You pull it to a position, set it down, raise the antennas, and work from the handle. It is not a backpack and not a handheld shield. This is a unit that stays where it is placed, which suits gates, roof edges, temporary checkpoints and other spots where one person watches one approach.

ETLD-PJ04 Trolley Drone Jammer 4-Band 2000m

Four Bands, Customizable

The standard set is 0.9GHz, GPS, 2.4GHz and 5.8GHz. Four channels are provided. Frequencies can be customized, so a site facing a particular link can ask for a closer match instead of carrying bands it never uses. The handle has switches for each channel, letting the operator run all four or isolate the one that matters.

Omni and Directional: Two Ways to Cover

Two antennas come with the case. The omni antenna covers all around the unit and is quoted at 0–1000m. The directional panel pushes energy toward a chosen path and is quoted at 0–2000m. Start with omni to watch the area, then switch to directional once a bearing is known. Both figures assume a clear line; walls, hills and heavy rain reduce them.

Power by Band

Output is 100W on 0.9GHz, GPS and 2.4GHz. The 5.8GHz channel is 50W. That lower figure is worth remembering: 5.8GHz still transmits, but it will not match the reach of the 100W bands. For sites where 5.8GHz is the main concern, ask the supplier about options before ordering. The high wattage explains why a case unit can hold a longer range than many body-worn devices.

Batteries and Handle Control

Four removable batteries are included. They can be swapped in the field, so a long watch does not stop when one cell runs down. The handle carries the channel switches; no laptop, phone or external controller is needed. The operator sets the bands, checks the antennas and leaves the unit running.

Setting the Case

Place it on level ground. Keep the antennas clear of metal walls and vehicles. Pick omni or directional. Switch on only the bands you need, and keep friendly radios and Wi-Fi out of those bands or accept that they will be affected. The case is heavy enough to stay put in wind, but secure the antennas if the site is exposed.

Where It Fits

Gatehouses, construction sites, event entries, prison perimeters and critical buildings are the usual uses. One operator can cover a gate or a roof edge. For a long perimeter, several cases or a mix of case and backpack units may work better. The trolley format moves easily between posts but is not made for stairs.

Limits to Respect

Custom frequencies must be confirmed before production. Omni range is half the directional figure. Jamming affects any device in the band, including friendly links. Local rules apply, and the case is a transmitting unit, so site coordination matters. Do not assume it is waterproof unless the supplier confirms the rating.

Bottom Line

The ETLD-PJ04 drone jammer is a simple four-band, high-power case unit. Roll it in, choose the antenna, switch the bands and cover the approach.

ParameterSpecificationNotes
Jamming frequencyCustomizable; 0.9/GPS/2.4/5.8GHzFour bands
Jamming rangeOmni 0–1000m; directional 0–2000mBest case
Channels4Handle switches
Battery4 × removableField swap
AntennasOmni + directionalBoth included
Output power100W on 0.9/GPS/2.4; 50W on 5.8GHzBand dependent
Form factorTrolley casePull and place
ControlHandle with switchesAny band on/off

Can I change the bands after ordering?

Custom frequencies are set before production. Confirm the exact bands and power levels with the supplier at order time; later changes are not a field adjustment.

Why does 5.8GHz have less power?

That channel is listed at 50W while the others are 100W. It still works, but do not expect the same distance as the 100W bands.

How far does it reach in all directions?

Omni coverage is quoted at 0–1000m. Directional coverage is 0–2000m. Both assume a clear line and good weather.

Can both antennas be connected at once?

The kit includes both, but operating them together depends on the configuration. Ask the supplier whether simultaneous use is supported.

How long will four batteries run?

Runtime depends on how many bands are active and how long you transmit. Rotate all four and charge depleted cells away from the operating position.

Is the case safe to leave in rain?

Do not assume it is waterproof. Confirm the IP rating with the supplier before leaving it outdoors in wet weather.

Can it be mounted on a vehicle?

It is designed as a pull-and-place case. Vehicle mounting should be confirmed with the supplier, as the antennas need a stable base.

Will it block our own radios?

Yes, if they use the same bands. Switch off bands you do not need and coordinate with site users before transmitting.

Do operators need training?

The handle is simple, but users should be briefed on local rules, antenna choice and which bands to avoid.

What is included in the kit?

The case, omni and directional antennas, and four batteries are listed. Confirm charger, cables and any carry accessories with the supplier when ordering.